![]() You can verify the configured combinations (and their optionset value) in your solution when navigation to the statuscode field: Example status & status reason combinationsĮnter your email address to subscribe to this blog and receive notifications of new posts by email. Just make sure the combination of status reason (statuscode) and status (statecode) is a valid combination or it will throw an exception. Party = new OptionSetValue(2) //Status reason if you want more details check my github Old. a little clean up TW: TW kernel is now out of RC and v1.0, Merged a few things from the AOSP-JB4.3 kernel There were a good amount of updates that are kinda hard to explain. We can now simply use: Entity party = new Entity("contact", new Guid(".")) Cut sheet setting 1/Cut sheet setting 2/Roll paper setting 1/Roll paper setting 2. AOSP-JB4.3: Added AOSP 4.3 kernel, has all the updates from CMs kernel as of this date AOSP-JB4.2: Sync with CM. This will keep them from being counted towards your device. Those special fields include the record’s status (statecode, statuscode), the owner of the record (ownerid), etc. If you have devices that will be inactive for long periods of time, you can mark them as Inactive. Prior to Microsoft Dynamics CRM 2015 (update 1) we had to use special messages when updating special fields. Status = new OptionSetValue(2) //Status reason Update status (statecode & statuscode) of a CRM record using C. To quickly detect the status of an inactive flow, set the inactive time to a small value however, this setting increases the frequency at which NetStream. Instead of (deprecated, do not use!): service.Execute(new SetStateRequestĮntityMoniker = new EntityReference("contact", new Guid(".")), Now since those special messages are deprecated we can now (and should) utilize the regular update statement. The full list of those special messages can be found on msdn, here. Als Schlüsselwörter für ein erfolgreiches Update wähle success Sollte eine spezielle Aktualisierung nur für IPv4 oder IPv6 stattfinden so verwende folgende Check -URL: Update-URL IPv4: Update -URL IPv6: Sowie folgende Update -URL: Update -URL IPv4. Those special fields include the record’s status (statecode, statuscode), the owner of the record (ownerid), etc.
0 Comments
Leave a Reply. |